sir pano po ung permanent? nawawala kc ung config pag narestart ang router.permanent po solution diyan, yung tutorial sa taas temporary po yan.
ρáíd posir pano po ung permanent? nawawala kc ung config pag narestart ang router.
ok na po, nagawa ko na permanent.ρáíd po
idol pabulong naman pano mo na permanent disable yung AP isolation?ok na po, nagawa ko na permanent.
nasa YøùTùbé gumagamit ng esp module.idol pabulong naman pano mo na permanent disable yung AP isolation?
All here might benefit from this..
"
Up to there is great but there is one command missing.
- Type control port_fw_eligiblity_switch disable and press Enter (no that’s not a typo in the word eligiblity!)
- Done. Close the command prompt window."
Switch back to the Config#
and then type "save"
it will write the changes just made to flash, thereby saving it. That way when the router powers off and then powers on again the config will be intact. No need to go in and change it every time the router power cycles.
Turn off TR069 protocol in all the places where it's enabled so the router can't be accessed remotely by PLDT's TR069 protocol servers.
You're welcome
WOAH, thanks a lot, i'd learn a lot! grabe yun lang pala yun, ayaw ko pa naman bumili ng usb ap isolation para sa repeater koAll here might benefit from this..
"
Up to there is great but there is one command missing.
- Type control port_fw_eligiblity_switch disable and press Enter (no that’s not a typo in the word eligiblity!)
- Done. Close the command prompt window."
Switch back to the Config#
and then type "save"
it will write the changes just made to flash, thereby saving it. That way when the router powers off and then powers on again the config will be intact. No need to go in and change it every time the router power cycles.
Turn off TR069 protocol in all the places where it's enabled so the router can't be accessed remotely by PLDT's TR069 protocol servers.
You're welcome